CUTBACK BITUMEN MC30

Cutback Bitumen MC30

General description of Cutback Bitumen MC30

Cutback Bitumen MC30 is dissolved of bitumen in solvents of kerosene. many countries derive kerosene and other volatile petroleum  products and add as a cutter or cutback agent to bitumen to reduce (or cutback) the viscosity of the bitumen.

The reduction in viscosity of bitumen aids construction of seal coats in road pavements as softened mixture wets the chips more easily.

Cutback agent evaporates from seal coat, cutback agent becoming a negligible component of seal coat a few months after application. If significant amounts of the cutback agent remain in the seal coat an unwanted long term softening effect may result.

Uses of cut back asphalt MC-30

Cutback bitumen MC30 also consist of initial incorporation of asphalt into the surface of non-asphalt based course preparatory to any superimposed treatment of construction.

In addition cutback asphalt MC-30 applying to waterproofing of surfaces, plug capillary voids, coat and bond loose mineral particles.

Cutback agents are used to lower the viscosity of bitumen when it is applied as a primer to the surface of a road pavement aggregate base course or substrate.

We use Kerosene as a bitumen cutback agent at different concentrations according to local conditions and requirements.

Cutback bitumen also is ideal for prime coat and cold applied. Because easy uses and no need to thinning and heating.

 

Packing of cutback bitumen MC-30

Packing of cutback bitumen MC-30 is in new thick steel drum. This drums are on pallet to prevent any leak inside of container also bulk in bitutainer and tanker.

Guaranty/warranty of cutback asphalt MC-30

PUB-LTD guaranty quality of cutback MC-30 with arrangement of international inspector. By checking bitumen quality and quantity on each shipment during loading to vessel. Also controlling production by QC team via batch test report before shipping. PUB-LTD guaranty quality to meet with ASTM/EN15322:2009

 

Analysis of Bitumen MC30

Properties

Min

Max

Test Method

Kinematic viscosity at 60°C [140°F], mm2/s

30

60

ASTM D2170

Flash point (Tag open-cup), °C [°F]

38[100]

-

ASTM D3143

Distillate test:

Distillate, volume percent of total distillate to 360°C [680°F]:

to 225°C [437°F]

-

35

ASTM D402

to 260°C [500°F]

30

75

ASTM D402

to 316°C [600°F]

75

95

ASTM D402

Residue from distillation to 360°C [680°F], percent volume by difference

50

-

ASTM D402

Tests on residue from distillation:

Penetration at 25°C,

120

300

ASTM D5

Ductility at 25°C [77°F], cm

100

-

ASTM D113

Solubility in trichloroethylene, %

99.0

-

ASTM D2042

Water, %

-

0.2

ASTM D95

  • Address:
    No 220, 32nd Floor, Tower 2, Altinoran-Sinpash, Turan Gunesh, Ankara. Turkey.

About Us

We believe that its very light version & Simple, Creative & Flexible Design with Standards

Support
  • Monday-Friday: 9am to 5pm
  • Saturday: 10am to 2pm
© Copyright 2021 Publtd