/Cutback Bitumen MC30
cutback bitumen mc30

Cutback Bitumen MC30

General description of Cutback Bitumen MC30:

Cutback Bitumen MC30 is dissolved of bitumen in solvents of kerosene. many countries derive kerosene and other volatile petroleum  products and add as a cutter or cutback agent to bitumen to reduce (or cutback) the viscosity of the bitumen.

The reduction in viscosity of bitumen aids construction of seal coats in road pavements as softened mixture wets the chips more easily.

Cutback agent evaporates from seal coat, cutback agent becoming a negligible component of seal coat a few months after application. If significant amounts of the cutback agent remain in the seal coat an unwanted long term softening effect may result.

Uses of cut back asphalt MC-30

Cutback bitumen MC30 also consist of initial incorporation of asphalt into the surface of non-asphalt based course preparatory to any superimposed treatment of construction.

In addition cutback asphalt MC-30 applying to waterproofing of surfaces, plug capillary voids, coat and bond loose mineral particles.

Cutback agents are used to lower the viscosity of bitumen when it is applied as a primer to the surface of a road pavement aggregate base course or substrate.

We use Kerosene as a bitumen cutback agent at different concentrations according to local conditions and requirements.

Cutback bitumen also is ideal for prime coat and cold applied. Because easy uses and no need to thinning and heating.

 

Packing of cutback bitumen MC-30

Packing of cutback bitumen MC-30 is in new thick steel drum. This drums are on pallet to prevent any leak inside of container also bulk in bitutainer and tanker.

Guaranty/warranty of cutback asphalt MC-30

PUB-LTD guaranty quality of cutback MC-30 with arrangement of international inspector. By checking bitumen quality and quantity on each shipment during loading to vessel. Also controlling production by QC team via batch test report before shipping. PUB-LTD guaranty quality to meet with ASTM/EN15322:2009

Analysis of bitumen MC30

50-

Properties Min Max Test Method
 Kinemalic 1 viscosity at 60°C, eSt 30 60 ASTM D2170
 Flash Point (Tag Open-Cup),°C 38 ASTM D1310
 Distillate test 2 :
 Distillate, percent by Volume of total 360°C
 To 190°C 15 ASTM D402
 To 225°C 20 60 ASTM D402
 To 260°C 50 90 ASTM D402
 To 316°C 80 90 ASTM D402
 Residue from distillation to 360°C:
 Test on residue from distillation Penetration at
25°C,100g, 5 sec.
 Ductility 3 at 25°C, cm 120 250 ASTM D402 / ASTM D113  Solubility in trichloroethylene, percent mass 100 ASTM D402 / ASTM D2024  Water, percent volume 0.2 ASTM D95