/Cutback Bitumen SC250
Cutback Bitumen SC250

Cutback Bitumen SC250

 General description of Cutback Bitumen SC250

Cutback Bitumen SC250 is dissolved of bitumen in solvents of kerosene. many countries derive kerosene and other volatile petroleum  products and add as a cutter or cutback agent to bitumen to reduce (or cutback) the viscosity of bitumen.  Mixture obtained, called cutback bitumen.

Reduction in viscosity of bitumen aids construction of seal coats in road pavements as softened mixture wets chips more easily.

Furthermore cutback agent evaporates from seal coat, it becoming a negligible component of seal coat a few months after application. If significant amounts of the cutback agent remain in the seal coat an unwanted long term softening effect may result.

Uses of cutback asphalt SC250

Cutback bitumen SC250 consist of initial incorporation of asphalt into the surface of non-asphalt based course preparatory to any superimposed treatment of construction. In addition the cutback asphalt SC250 applying to waterproofing of surfaces, plug capillary voids, coat and bond loose mineral particles.

Cutback agents are used to lower the viscosity of bitumen when it is applied as a primer to the surface of a road pavement aggregate base course or substrate. Also we use Kerosene as a bitumen cutback agent at different concentrations according to local conditions and requirements.

Cutback bitumen is ideal for prime coat and cold applied because of easy uses and no need to thinning and heating.

 

Packing of cutback bitumen SC250

Packing of cutback bitumen SC250 is in new thick steel drum. This drums are on pallet to prevent any leak inside of container. Also bulk in bitutainer and tanker is possible.

Guaranty/warranty of cutback asphalt SC250

PUB-LTD guaranty the quality of cutback SC250 with arrangement of international inspector. By checking quality and quantity of the bitumen on each shipment during the loading to vessel. Also controlling the production by QC team via batch test report before shipping. PUB-LTD guaranty the quality to meet with ASTM/EN15322:2009

Analysis of bitumen sc250

PROPERTIES MIN MAX TEST METHOD
 KINEMALIC 1 VISCOSITY AT 60°C, EST 250 500 ASTM D2170
 FLASH POINT (TAG OPEN-CUP),°C 80 ASTM D1310
 DISTILLATE TEST 2 :
 DISTILLATE, PERCENT BY VOLUME OF TOTAL 360°C
 TO 190°C ASTM D402
 TO 225°C ASTM D402
 TO 260°C ASTM D402
 TO 316°C 4 20 ASTM D402
 RESIDUE FROM DISTILLATION TO 60°C:                      800        10000
 TEST ON RESIDUE FROM DISTILLATION PENETRATION AT
25°C,100G, 5 SEC.
60
 DUCTILITY 3 AT 25°C, CM 100 ASTM D402 / ASTM D113
 SOLUBILITY IN TRICHLOROETHYLENE, PERCENT MASS 100 ASTM D402 / ASTM D2024
 WATER, PERCENT VOLUME 0.2 ASTM D95